Pair of H8/H9/H11 LED fog light bulbs with aluminium body, 3030 SMD chips and red H11 gasket

H8/H9/H11 LED Fog Light Bulbs, 2-Pack 6000K White 360° Beam 12V Plug-and-Play Replacement for Fog Lights & DRLs

$25.99
Skip to product information
Pair of H8/H9/H11 LED fog light bulbs with aluminium body, 3030 SMD chips and red H11 gasket

H8/H9/H11 LED Fog Light Bulbs, 2-Pack 6000K White 360° Beam 12V Plug-and-Play Replacement for Fog Lights & DRLs

$25.99

✓ FREE Standard Shipping on every order

✓ Ships from our US & overseas warehouses

✓ Questions? Contact us

In stock

A pair of plug-and-play LED bulbs that drop straight into an H8, H9 or H11 socket and light up your fog lamps or daytime running lights in crisp 6000K white.

What you get

  • 2 x LED fog / DRL bulbs (one pair)
  • Fits H8, H9 and H11 sockets - no adapters, no wiring changes
  • Sold in a plastic case; the pair ships at 68 g

Why it is easier than a halogen swap

  • Original H8/H9/H11 connector on the base, so it replaces the halogen bulb directly - no cutting or splicing
  • 3030 SMD LEDs around the body plus a top-mounted chip behind a condensing lens, for light out to the sides as well as straight ahead
  • Aluminium alloy body with ABS housing to pull heat away from the chips
  • IP65 rated against water spray and dust

Specifications

  • Socket: H8 / H9 / H11
  • LED type: 3030 SMD
  • Light colour: 6000K white
  • Rated output: approx. 1000 lm per pair
  • Beam angle: 360°
  • Voltage: DC 12V
  • Rating: IP65 water-resistant and dustproof
  • Bulb size: 6 x 4 x 3 cm (2.36 x 1.57 x 1.18 in) each
  • Bulb weight: 27 g each
  • Pack size: 12.5 x 12.5 x 3.8 cm (4.92 x 4.92 x 1.50 in)

Fitting notes

  • For 12V vehicles only. Check the bulb your car takes before ordering - H8, H9 and H11 share the same connector but the housings differ
  • Built as a fog light and DRL bulb. LED retrofit bulbs are not DOT-approved as headlight replacements in the US, so check your local road-use rules before fitting them to a headlight housing
  • If the car's bulb monitoring system reports a fault, the lamp may need a load resistor (not included)
  • Let the housing cool before fitting, and do not touch the LED chips with bare fingers

You may also like